"Dog Balls" Captured ball ends for the HPI Baja Constructed of Heavy Duty Stainless steel to resist corrosion Allows for the rod end to pop off retaining strain relief but captures it to finish the race. Requires no modification for installation Oversized ball to remove slop from the steering Built in stop point when at full droop Kit contains: (2) Inner ball ends (short) (2) Outer Ball ends (Long)

Installation Video:

COST: $45.00

This motor offers great Low end tourqe with the HP to pull taller gears while keeping the RPM's.
Motor performs very well with a rear dom or CPI Big Bore. Small bore for those that need to calm her down a little (Like myself). I've run a 990 and a 668 carb on them, 668 does well but the 990 seems to do better.
Build consists of all brand new parts including hardware:

Zenoah 34mm 4 bolt cylinder with "Dog Pile Wild Child" porting
Relieved 34mm Piston
+1mm Stroker crankshaft
New base gasket
Zenoah 4 bolt cases
NGK CMR7H plug
Case snap ring
Cases are built with (2) new Nachi 6001 bearings and stock style seals. This differs from factory by removing the third bearing and greatly reduces the chance of an air leak through the case seals.

A hole from the transfer port area to the clutch side case bearing is also added for better oiling to prolong bearing life.

COST: $299.00